Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,as the technote "Radio Ressource Management under UWN" (<A HREF="javascript:newWin('http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a008072c759.shtml')">http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note0918...
Hi,we use 3 WLC4404. Two of them on location A (130 APs), the third on location B (40 APs). Both locations are connected via 10GE-MAN, and 10km away. Now one could say I could put the controllers of location A and location B into two different mobili...
Hi,WCS: 5.0.56.2WLC: 5.0.148When I rollout an accesspoint template I always get the following error:Partial Failure:**ap parameters**Provision Failure: mediation-1, unspecified error,lrad,apPwd,Lrad![AP-Mac-adress]Most of the changes arrive at the ac...
Hello,3xWCS 4404 with 5.0.148 and WCS 5.0.56.After serveral days, I were not able to connect to the telnet, SSH and webfrontend interfaces on all controllers. I tried management and service-port IPs. But I get ping responses from the interfaces and t...
Actually I have the following X-File: Since several firmware releases our 4404 WLCs report two Rogue APs as on our network. But they are definetively not on our LAN. They are in neighbour buildings but they belong not to our university. The buildings...
Yes. The behaviour is the same. I get "Unable to set tx power control threshold." when trying to change a or b and the output shows -65 on a and b/g too. It was only a coincidence that one example was 802.11a and the other 802.11b.
Before one asks: yes, I did the intermediate updates as Cisco instructed in the release notes. I did not jump from 3.2 to 5.2 directly. And the release notes do not indicate that the change will be done automaticall during a firmware upgrade.
We have the controllers since 3.2 and thats why the power setting is still at -65.(Cisco Controller) >show advanced 802.11b txpowerAutomatic Transmit Power Assignment Transmit Power Assignment Mode................. AUTO Transmit Power Update Interv...
There is a street and respectively a railway track between our buildings and the other two.I thought maybe the users of the other APs are connected to our LAN via VPN but that is also not the case.
Hi,we are experimenting with that rogue feature too. Especially because we want to know, how that works, which type of protocol are used for informing the controller. Because it is annoying to know, that the controller received a packet which indicat...
