Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have this ongoing issues unresolved for somedays now. Got two sites connected by MetroE link and each side equipped with C2811 router witch HWIC-4ESW. Under full load on the F0/0/0 port (load 253/255) im starting to see ping drops.Needless to say F...
Like clear counter int fa0/0- is there any command to clear the counter under controllers fa0/0?eg. im seeing these conuters under controller fa0/0:Bytes_recvd 2349082481 Bytes_sent 2040588177 Frames_recvd 282629943 Frames_sent 209684194total_bytes_R...
for the benchmark testing,connected two c2811 router back-to-back with RJ45 cross cable and used the command TTCP to test the thrughput. One c2811 acting as transmitter and the other acting as receiver. However repeatedly im getting the througput of ...
Im having problem establishing a remote isdn bri site to establish the call to HQ.I can see that when i do the " clear int bri 1/0" the layer 1 active and layer 2 mutiple frames established.however when i try to do a test call " isdn test int bri 1/0...
Check this out:http://www.cisco.com/en/US/prod/collateral/routers/ps274/product_data_sheet09186a0080091b8b.htmlDont buy NM-4T for you 2620 router, as it wont work.You still be able to run those routing protocols.you can plugin NM-4T into 2620, but it...
i have seen in 7200VXR model, can list out clock rate under the "sh controllers serial" command.Probably cisco can import such codes in ISR routers too!Cheers!
