Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On a site to site vpn we have interruptions every 1-3 hour lasting for 5-10 seconds. All applications connecting through this tunnel have to restart.There are two Riverbeds in the VPN path, the MTU size is 1380, the tcp options have been set in the g...
Hello, on the ASA 5510 configured with a site to site VPN tunnel i get the following messages : Jan 15 2009 12:10:50: %ASA-1-713900: Group = 123.123.123.123, IP = 123.123.123, construct_ipsec_delete(): No SPI to identify Phase 2 SA! Jan 15 2009 12:10...
Hello,user connecting with the VPN Client to my ASA 5510 could access ressources in the internal Network 192.168.115.0.But there is no access through the ipsec tunnel to the DMZ Network 192.168.116.0.VPN clients get Addresses from 192.168.113.0.There...
Hello,i tryed to configure a etherchannel between a Catalyst 4006 CATOS 7.3 and a 2-stacked 3750 switch. I used 2 GB FX Ports.I uses LACP with mode actice.The ports did not build the channel.Can there be a general problem with this hardware/software ...
Hello,on a Cisco 836 CBAC is enabled on the inside Eth0 interface for incomming traffic. If on the outside interface BRI0 for ISP connection used all incomming ip traffic is blocked for returning traffic from initiated inside.Is CBAC working with dy...
The tunnel has worked perfect bevor the migration.I migrated a PIX 515 to a ASA 5510 with the PIXtoASA migration tool.There are 4 tunnels in a hub to spoke toplogywith PIX 506 at the spoke endpoints.2 tunnels work without error messages after the mig...
Hello,please see the attachment.There is a entry in the root table when a RA-VPN connection is established.But no traffic will flow form DMZ to VPN Client.Thanks Peter
Hello srue,there is no Nat rule between the DMZ and theExternal Interface.In the packet trace i see that packet from hosts in the DMZ route traffic to VPN LAN 192.168.113.0/24 send the packet to the default route, that is the external interface.I wil...
Hello,i forgot to mention that i was using cross stack Etherchannel. I think the problem is that the C 4006 is using PSTP and the C3750 is configured with STP.Can this be the issue ?Peter
