About HimeshGohil

HimeshGohil · 08-25-2021

I've got issues with a Firepower Module on our system and will be re-installing it.I've researched the method and I've never done this before and would appreciate a sanity check to see if I'm missing anything before I go ahead and submit the change d...

HimeshGohil · 08-18-2021

Hi, we've been having issue with one of our Firepower modules.I've tracked the issue down to the /boot disk being full. Here's a listing of the files; root@Firepower:/boot# ls -lahtotal 51Mdrwxr-xr-x 6 root root 1.0K Sep 3 2015 .drwxr-xr-x 22 root ro...

HimeshGohil · 07-08-2021

Hi, our setup is;ASA 5555-x active passive HA pairFirepower module installedUsing FMC for FP management My question is, what is the best way to backup FP specifically for an upgrade project where I can easily restore FP if I have issues with the upgr...

HimeshGohil · 07-07-2021

Hi, I'm researching my plan to install updates on our ASA 5555-xI can download the ASDM and Firepower modules direct from the Cisco website and the updates for the ASA aren't available. Can I download them from anywhere or will I need to contact a TA...

HimeshGohil · 08-13-2019

Hi all,I consilidated two 2960x switches into a stack. Both have multiple VLANS and I'll give an example here;sw1vl 2, 3, 4sw2v 12, 3, 4, 5 I decided to re-use sw1 keeping the config, wiped sw2 and stacked.So far so good.After configuring the uplink ...

HimeshGohil · 08-25-2021

Thank you Chakshu, that's a really good tip.I'll add that to my plan

HimeshGohil · 08-18-2021

Thanks both.I've been researching re-imaging in any case as I thought that's what I'd need to do to recover my module. The disk full and your comments confirms this.I'll have some other questions on re-imaging as I've not worked on these systems much...

HimeshGohil · 08-18-2021

Thanks.Yes on an ASAI was hoping to clean it up and upgrade it properly as we have three other ASA's and they all need upgrading (both the ASA and FP software).Fixing this FP module is the first part of the upgrade plan.I'll wait to see if anybody el...

HimeshGohil · 07-20-2021

Hi, I also have this issue.I have copied .xml files across to the secondary. Is there anything else I should do?They don't show up in ASDM yet, would a reboot or failover help that? Thanks

HimeshGohil · 07-08-2021

Thankyou Marvin.So if I were to take a backup using the FMC and an issues causes us to loose the FP module I would then need to;Remove the FP module from the ASAInstall a new FP module taking it up to the same software version that the backup was tak...

Member Since	‎08-13-2019 07:24 AM
Date Last Visited	‎09-09-2022 07:28 AM
Posts	13

User Statistics

User Activity

Re-Installing Firepower on ASA

Firepower boot disk full

Firepower Backup

Obtain Updates for ASA

VLAN Trunk Issue

Re: Re-Installing Firepower on ASA

Re: Firepower boot disk full

Re: Firepower boot disk full

Re: ASA's 5520's Active/Standby not syncing AnyConnect Profles

Re: Firepower Backup