Dear All,Please help:In the network we installed Cisco7604 and installed SUP32 as the active/standby (SSO), we found the pinging to SUP32 got huge delay sometime.. What we need to check? Diagram as below:
I am doing NAT from IPv6 to IPv4 on GGSN, from log it can translated from IPv6 to IPv4 normally:================SAMI 3/4: Nov 19 05:29:30.006: IPv6 NAT: IPv6->IPv4: src (2001:236::CDC8:1D93:7CA6:58B1 -> 10.100.112.8) d...
We have configured according to document 12490cfg_release_9.pdfAs the Ipv6 stateless autoconfiguration :====================interface Virtual-Template10 mtu 1280 no ip address ipv6 enable ipv6 nd prefix default infinite infinite off-link no ipv6 nd r...
Dear Giuseppe,Thank you very much for your translation, I will take a look and check as you recommend.Yes that help a lot at least make me feel better.Even it is technical matter but I am still human.
Dear Paolo,Thank you for answer and advise, but normally it should not happened,We did also test pinging the end point and facing quite similar.=====================================================ping -t 172.24.6.211Pinging 172.24.6.211 with 32 byte...
