Hello I'm trying to setup PBR and ran into an issue.  I'm need to have dual default gateway depending on traffic, but I can only set PBR for 1 VLAN.  I need a default route in the routing table, and a default route for matching traffic in the PBR.acc...

Hello,I have setup a RSPAN vlan over 2960 switches.  Everything seem to be working great, except that I only receive the Tx traffic, no Rx, is there something worng in my config? typical access port:interface FastEthernet0/10 switchport mode access i...

Hello, is it possible to customize user roles or rights in CW?For example when I create a new user, I have a choice of the following pre determined roles:-helpdesk-approver-Network operator-network administrator-system admin-export dataSo is it possi...

Hello everybody,  anybody here has ever configured 802.1x and WOL?I have this configuration:interface FastEthernet0/34 switchport access vlan 5 switchport mode access no logging event link-status duplex full authentication control-direction in authen...

Anyone can tell me in general how much polling interfaces data with SNMP will affect the CPU?For example, I have a 4507E and I'm polling in/out bits/s and errors every 5 minutes for 6 PO interfaces.  I don't see any impact at all on CPU.Now there are...