Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys
I'm writing because I have observed something strange on one of the 9300 stacked switches. I thought I had found a solution by creating a port channel within the same NIM module instead of spanning across modules. In that case, we experien...
Hello, I have set up a stacked C9300 switch with 2 SPAN sessions. In the stack, switch 1 is configured with some copper ports defined as sources, which send traffic to the destination monitor port on the upper NIM module. I have connected a PC with W...
HI Guys.Quick question Is it possible to create a SPAN port on a C9300 and configure port (monitoring) so it's not possible to sent data through it only recieving data? Thanks in advance /Jeppe
Hello, I've read the document, but I couldn't find anything about limitations. Can you specify where in the document I should look?monitor session 1 source interface Gi1/0/1 - 24 rxmonitor session 1 source interface Te1/1/1 - 2 , Te1/1/5 - 8 rxmonito...
