Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have this 2 new APs falls under U-Boot mode. Please assist me. u-boot>> printenvBOOT=part1CASset=maxENABLE_BREAK=1FACTORY_RESET=0MALLOC_len=5MANUAL_BOOT=0MEMORY_DEBUG=0MPmode=SMPautoload=yesbaudrate=9600bootcmd=nandbootbootdelay=3bootfile=board_ini...
Recently i received many log below:There is another error for IPv6. I check on Cisco web it due to firmware bug, Anyone can advise me how to resolve it?Aug 2 13:57:05: %IPV6_ND-6-DUPLICATE_INFO: DAD attempt detected for 2400:3C00:2:6189::1 on Vlan89...
Will this bugs cause ESX hang? I have experience it on primary Nexus switch, however it works fine on secondary Nexus switch. When incident happen i have to reload primary Nexus switch in order to bring back my ESX services. Secondary Nexus switch do...
How to check the Upgrade license if running on SUP1 engine? bin file? 9400-PROD#sh verCisco IOS XE Software, Version 16.09.02Cisco IOS Software [Fuji], Catalyst L3 Switch Software (CAT9K_IOSXE), Version 16.9.2, RELEASE SOFTWARE (fc4) Technology Packa...
Hi, i had the same problem on my stackwise pair too. Appreciate you can share what is the resolution from Cisco. I have saved the config file prior to power cycle the switch. Confirm both running & startup config are the same. However, after power cy...
