Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been having a problem with getting microsoft-ds (445/tcp) connectivity between servers at two different sites. It looks like the routing and the firewall rules are setup to allow the traffic, but when I attempt to connect, I'm getting the follo...
First, let me start by saying I'm an idiot. I started to rebuild a router without saving off the PKI cert from my CA. Now, when I go to re-enroll, I get the error:%CRYPTO_PKI: CA Cert not yet valid or is expired -Is there a way to have the router r...
I have a subnet that has a Cisco load balancer in it that is in the process of moving. The current subnet is behind a FWSM and has been working for years. The new subnet will be in front of the firewall. In the current state, the default gateway a...
I'm attempting to troubleshoot a problem from one of our frame-relay links back to an ATM DS3 at our data center. Does anyone know if there's a way that a Catalyst 7200 can track incoming packets that have been marked with a FECN or DE flag set? I ...
Does anyone out there know what hardware to use to connect a 56k DDS line from AT&T to a Cisco Catalyst 2821? This router is replacing an older EOL router and I'm not sure what cards are supported that can be used to accomplish this task. Thanks in...
The hard part is that all the users from various IP Networks will be coming in as the source. I'm not sure how to write the group command to handle this.As for the topology, it is unsecure to be doing things this way, but we're migrating the servers...
The 'group' command is for source nat with respect to the servers behind the CSS. I need to do SNAT for incoming requests. I've attached a Visio diagram of what I'm talking about.
Hi Rob,Yeah, I originally had that radius username and password that was set on the AP for the wlccp config in for the WLSE WLCCP Credentials, but that wasn't working. I then tried to use a radius account that I made specifically for the WLSE to do ...
