Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey all,I got a "new to me" 5520 and I am trying to download and setup ADSM, but I am getting nothing but the "connection reset" error from all browsers. I have used the following commands and this is the versions: http server enable 4443http 192.168...
Hey all,I have setup a SSL-VPN using my 2811 and I am getting this error with my PC, no matter what location I am at (work, Public Wifi, friend's house):"The service provider in your current location is restricting access to the Internet. You need to...
Hey all I am attempting to get an SSL-VPN working for my home router and not getting much success. When I attempt to connect it errors saying, No valid certificates available for authentication. Attached is my config and version information for rev...
I had my ssl vpn working and now the anyconnect client that I downloaded just says Contacting... It will not give me an error at all. If I use the Anyconnect App on my droid phone it says "Anyconnect cannot confirm it is connected to your s...
Hello all,I have been working with FreeNAS to do my TFTP service for me and it has worked great for the most part. I do config backups after every change to the server just fine and sometimes in reverse, but the other day I was going a IOS upgrade f...
ok so this is how i solved this. Installed firefox version 15, failed butshowed me "ssl_no_cipher_overlap" so Google that. SaysI need to enable ssl encryption rc4-md5 aes128-sha1 aes256-sha1, when I dothat it says: The 3DES/AES algorithms require a E...
I downgraded to my earlier 3.1 client to confirm and that version doesnt seem to have the ability to Disable Captive Portal Detection. I also can't open a TAC as I am not under a contract. I am a college student trying to set this up. If there a...
I just upgraded my client to the 4.2 client to see if it was a bug with the 3.1 version. Both versions show the same results. I am currently using the 4.2 version.
