Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have some computer,they're mac address decide by software.Now we find some same mac's computer in a switch.The same mac's computer belong to different vlan. Why the same mac's computer work well? The switch is Catalyst 2950:show mac-add ...
In one router,I configure two ospf processes .I want to know if one ospf processes can know the other processes's routing information without redistributing ?
Hello, I configure isis and ospf redistribute like this: R1---12net---R2----23net----R3 ISIS L2 OSPFWhen I redistribute ISIS into OSPF on R2 , I see any other ISIS routes behind R1 but I don't see the 12 network which is c...
Hello:In the url:http://www.cisco.com/warp/public/cc/pd/si/casi/ca3500xl/prodlit/cfig3_an.htmThe url say :The Catalyst 6000 and the Catalyst 4000 switches support a special multiservice port to connect to the Cisco IP phones. The Catalyst 3500 series...
Pvlan can work across a trunk. Just like a normal vlan. But if you do promiscuous port in a trunk port . You should do it only in Catalyst 6500 or Catalyst 4000. I do it in catalyst 6509 port 15/1 and 16/1 successfully.
Ben,Thank you for your replay.I want to ask a question about voice vlan Y. The voice vlan Y is like the normal vlan X? And I should create voice vlan Y like this :sw#vlan datasw(vlan)# vlan Y sw(vlan)#exitinterface vlan Yip add 1.1.1.1 255.255.255.0...
The ios version is :cat6000-sup2k8.7-1-2. When I reboot the switch , the message disappear. And I worry about that if I reboot the switch next time , The message will appear again.
Thanks Don.I read the access-list in the url:http://www.cisco.com/warp/customer/459/15.htmlBecaust It is cisco's document, I don't know whether It is right or not?
