01-22-2003 04:51 AM - edited 03-02-2019 04:25 AM
Hello,
I configure isis and ospf redistribute like this:
R1---12net---R2----23net----R3
ISIS L2 OSPF
When I redistribute ISIS into OSPF on R2 , I see any other ISIS routes behind R1 but I don't see the 12 network which is connecting the two of them. I have seen this on both Frame Relay and Ethernet, I have used a redistributed connected matching a route-map to get the network into the table but is there any other way?
01-28-2003 08:16 AM
Take a look through the following link on setting up IS-IS for more information on configuring redistribution.
http://www.cisco.com/univercd/cc/td/doc/product/software/ios113ed/113ed_cr/np1_c/1cisis.htm
01-28-2003 12:27 PM
If you have a network statement in your ospf config for the 12 network this network will be preferred over ISIS since the AD of ospf is 110 and ISIS is 115.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide