Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
To who can help, I'm trying to get my wireless to work. I'm basically trying to configure the Dot11radio 0. Based on an old post, I believe it said something to the extent of, when doing subinterfaces, the subinterface can't be on the same interface ...
Community,I've been trying to transfer my IOS to a new card that I put in my 800 series router. When I replaced the original card, it went into rommon mode. I've been trying to different methods, but it seems to be an issue with reaching my tftpd ser...
Community,I was trying to upgrade the memory in my router, so I switched the card to one with more memory. The result of me doing that was I was stuck in Rommon mode. I was trying to emulate a tutorial that I saw on YouTube, in which the instructor s...
To whoever can help, I have a couple of 871W routers, and I'm wondering if Cisco has an archive update location where we can find the upgrades. I know these routers have gone unsupported, but when they were supported, Cisco did help me with the upgra...
I was able to get it to work trough Xmodem. Part of the process makes you select the type of recovery, and I was selecting Ymodem with recovery. Once I selected Xmodem, it worked. Thank You
First, I'm new to bridging, but I wanted to clarify that I have a 871W router, and I have the FE4 and vlan1 interface bridged. I called the bridge bridge-group. The internet actually works pretty good, except for that error message. Previously, I tri...
