02-04-2020 05:10 AM
Community,
I was trying to upgrade the memory in my router, so I switched the card to one with more memory. The result of me doing that was I was stuck in Rommon mode. I was trying to emulate a tutorial that I saw on YouTube, in which the instructor switched his Baud Rate settings to 115200. That was a huge mistake because, I can't understand anything on the screen now, and I feel that I've hosed the router. I know it still works, but I can't do anything to it.
This isn't a production router. I'm just using it to train myself.
Has anyone experienced anything like that before? Any help would be appreciated.
Regards,
Solved! Go to Solution.
02-04-2020 05:49 AM
Hi there,
Once you change the baud rate on the device you then need to change the baud rate configured on the existing serial session.
cheers,
Seb.
02-04-2020 05:47 AM
Hi @woodstar
Queries
Did you change the baud rate on the router?
If so, then change the baud rate in your emulator to match what is set.
Did you change the baud rate on the emulator?
Then return the baud rate to the default value (9600).
Regards
02-04-2020 05:49 AM
Hi there,
Once you change the baud rate on the device you then need to change the baud rate configured on the existing serial session.
cheers,
Seb.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide