Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the following Asus RTN16 Router ( WIth Tomato Shibby Firmware) TWO VLANS (Plus Default )deployed on router , #3. #4 TWO Gateway Interfaces for each VLAN ( 10.10.3.1 & 10.10.4.1) SG300 Smart Switch ( In Layer 3 Mode ) VLAN Trunk tagge...
OK So I have the DHCP relay working on one switch but , now not sure where to connect a second switch on this topology . Should I connect the second switch to the router , or should I connect it to the first switch Please see updated diagram
Update ; I have now got the inter VLAN and relay working ( with one caveat *) . The main issue was that I was mixing and matching the VLAN interfaces on the routing hardware . The VLANS are now exist on just the switch - This is important because , t...
@leecoxhouse1 wrote:To me it really does not make sense to use a L3 switch and an all in one router. The L3 switch cannot route the wireless since it is built-in to the router. Your post is not making sense, no wireless was mentioned in post I was ...
@AlKor wrote:Its becouse GE23 was not a member of VLAN4Now work ?Hi Making G23 a trunk made no difference , I was able get network flow on on either access ports before , when statically assigning IP's for their relevant subnets . However it seems ...
