Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello people i hope you can help.I am looking at options of swapping out our Core switch with a 9406R chassis with multiple blades etc. I am currently getting prices for this. However as i work in a large secondary school the budgets are tight so was...
Hello,I work in a large secondary school and need to replace our current 6509 core switch. I have been looking at the 9400 with the following specs.1 x Cisco Catalyst 9400 Series 24-Port 1 Gigabit Ethernet (SFP) Line Card (C9400-LC-24S)2 x Cisco Cata...
That's good advise. I will take a look at the 9300 and compare prices.If i had 2 x 3850 in a stack and 1 switch failed say the master, would the routing and ACL's etc continue to work? Apologies for my weak knowlege in this area. Just starting to loo...
That is really helpful. I think i may go 6 slot 9400 as i don't need 3.2Tb bandwidth. I've discussed with the Netowrk manager and we're thinking we'll go with a mixture of 1 and 10Gb fibre and a blade of multi gigabit copper ports. As we usually buy ...
So yes basically they support PC's Laptops, IPhones and printers, the same for 3 of the 10 gb switches. The remaining 7 10gb switches are purely for WiFi access points and have 12 x 2.5Gb ports, they are Cisco 350 series
Yes so basically we have a Star Topology with the Core at the centre and roughly 50 x Cisco 2960/ 3750X etc running from this. Most of our switches have a 1Gb fibre uplink but we have roughly 15 x 10Gb switches with uplinks to our distribution switch...
