Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ciao,we are analyzing an identical problem that involve a stack of 2 C9300-48P in release 17.9.4abasically the trigger of this behavior apparently was a flap of two trunk interfaces that carry the management vlan.- in our case this vlan is an extende...
ciao!
I tested the configuration in my LAB, the behavior is perfectly the same as in your LAB.
- I can see the translation on edge1, but I cant ping from 10.6.9.6 to 192.168.1.1 (10.6.9.6 is correctly translated to 10.10.10.1)
Site1-cEdge01#show ip n...
ciao!
did you try ping end to end between cEdge and vSmart?
if ping is OK, check these info:
- certificates are correctly installed on cEdge (from CLI show sdwan control connections)
- cEdge list is correctly pushed on vSmart (from GUI configuration ...
ciao!
ok, so the problem is present also by using a classic ARP process?
then, can you share the output of show spanning-tree vlan <xyz> when the portfast is NOT configured under the interface and also after enabled it?
thanks for patience
TKKFabioN
