Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am using pix 515-E to configure remote access vpn. I am able to connect vpn and i also get ip address from PIX firewall. However i am not able to accee any thing. I checked on vpn client machine and found that cisco vpn client is not receiving a...
Hi,for multicast traffic testing i have cisco 3560 switch and cisco 2950 switch. if i create multiple VLANs on cisco 3560 switch and if i am doing testing multicast traffic by keeping multicast server in one vlan and test machine in other vlan it wor...
Hi,i have two cisco 3550 switch in HSRP mode. i have configured multiple vlans on this switch. i want vlan 1 users to get ip address in the range 192.x.x.x to their machine and vlan 2 users to get ip range 10.x.x.x.is it possible??
Hi,i have two cisco 3060vpn concentrators. one is in prodution and the other is in spare. i am planning to install spare vpn concentrator in failover mode so that if the current vpn concentrator goes down then the new vpn concentrator will take the c...
I have Cisco CUCM 6.1.2, earlier all phone was able to auto register but now it is not registering. I have tested 7940 , 7975 and soft phone.<br /><br />I have deleted one working phone from call manager after deleting it is stop working error on 794...
Hi,thanks for your prompr response. yes it is working on 3560 switch. My question is where do i need to configure command " ip igmp join-group 235.x.x.x.??
Hi Manmood,thanks for your help. i have just one question.if any pc boots for the first time it will send DHCP Braodcast request to get ip. so whether that PC will get the ip from the correct dhcp scope?
Thanks it is now resolved.I have gone through yours solution "I have gone trhough route plan report for unassigned DN's, and i deleted unassigned DN, after that I am able to do autoregistration , thanks for this help.
