About ComputerArt

ComputerArt · 10-18-2010

Switch#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Switch(config)#interface Vlan2 Switch(config-if)#ip address 10.1.2.1 255.255.255.0 Switch(config-if)#no shutdown Switch(config)#interface FastEthernet 0/1 Switch...

ComputerArt · 10-25-2010

Hello, I have one more question.you can enable NAT on Catalyst 3750?ThanksClaudio.

ComputerArt · 10-21-2010

Hello Akhil,I managed to get into the router 10.10.10.138, I set route 192.168.0.0 255.255.255.0 10.10.10.80 and now everything works.this is right?There are packages that bounce between the switch and the router?If I had not had access to the router...

ComputerArt · 10-21-2010

Here is the file with the data acquired.

ComputerArt · 10-20-2010

What should I look for wireshark?

ComputerArt · 10-19-2010

Perhaps there is some hidden ACL that blocks traffic?If I use 10.10.10.138 to go on the internet because I do not ping.Why can not I access the web page http://10.10.10.138?Switch#ping ip 10.10.10.138 source 10.10.10.80Type escape sequence to abort.S...

Member Since	‎10-18-2010 12:19 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	21

User Statistics

User Activity

Problem with routing catalyst 3750

Re: Problem with routing catalyst 3750

Re: Problem with routing catalyst 3750

Re: Problem with routing catalyst 3750

Re: Problem with routing catalyst 3750

Re: Problem with routing catalyst 3750