Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having a problem where calls that are forwarded from phone A to phone B still go to the voicemail of Phone A instead of the voicemail box of Phone B. I thought there was a setting somewhere to change it to the behaviour so the call will end up g...
Have been using the callback feature in callmanger for some time now and works fine. However, I would like to extend this feature somehow by having another softbutton ("send to voicemail") along side the callback softbutton when busy tone is triggere...
I believe you can have either BNC or rj45. We have quite an old NTE BT box it did have BNC but when we went fully IPT/ VoIP I asked the BT engineer if he could set the interface to rj45, the interface was there but not activated. He just changed the ...
quescom do a couple of different products, that we decided to use. http://www.quescom.com. we went with them because the quescom GSM400 was "cisco callmanager compatible". Another company that does GSM gateways is http://www.2n.cz but don't know too ...
The "publisher" keeps the master-copy of the database.The Publisher is responsible for changing the database when any configuration changes are made, it then publishes (sends out) the database to other specified CallManagers (subsribers)Subsribers ...
Yes I have 8.0(1b) installed too. My setup that Unity does a release to switch to a huntgroup / pilot point, and I have a unity subcriber as "always route member" I only get this problem when all hunt group members are busy or logged out. Therfore un...
We are having similar problems I think. We upgraded to ccm 4.1.3 and unity 4.0.5, with "release to switch", with enabling diagnostics I am getting Event ID 559 Cisco Unity's telephony component has encountered a serious error.EXPLANATION:A serious fa...