Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
I have a question some of you experience network designers or engineers may be able to assist me in. My current dilemma deals with the static default route for my remote branches. My architecture is basically a dual hub with spokes....
Hello everyone,
I am looking to upgrade our 2x ASA 5510 from ASA version 8.4(7).30 to 9.1(7). From everything I have read, I think I should be beyond the configuration migration point of NAT or ACL's because I am already at the latest version of 8.4...
Hello everyone,
I have had a strange issue thought I may ask the group. I have a fleet of 891F routers, IOS 15.5(3)M. For these routers we use mac-address table security since they don't have switchport security. This has been working mostly well....
Hello everyone,
I am running into a snag deploying our two new Nexus 56128P. Both are utilizing vPC pairs for switch access. I also have a vPC peer going to a 2960X which serves as a small aggregation for the core Nexus and FW and core router(4451)...
Hello all. I have been searching Cisco docs and threads but can't find a clear answer to my specific scenario. Basically, can I have multiple tunnels, with different IPSec profiles, on a single DMVPN hub utilize the same WAN interface & IP. My sce...
Thanks for the reply Philip. One other question about the upgrade I haven't seen a clear answer on. I will be going from ASA 8 to ASA 9. Am I still going to be able to do the zero interruption upgrade of the active/standby cluster. I have read th...
Victor,
That is correct...only pings to/from the 5k's drop, going through to anything is 100%. I saw your first response that it is probably CoPP and that seems to be it. Thank you for clarifying...gives me some peace of mind to continue my deploym...
Victor,
Also, I may not have exactly understood last night what you were asking about pinging through the switch. Since this is still dev, I only have one client on the switch actively. And that is actually in a switch stacked that is uplinked to t...
Victor,
Thanks for the info. Clearly I assumed incorrectly that n7.2 on the 5600 series would function the same. That's my bad. To that end, do you have any thoughts on Cisco documentation that says unicast routing should work, although not recomm...
