I want to confiure Bc and Be values for traffic shaping, but as soon as I give those values to shape average command, it fails.policy-map ethernetconnect_1gbit
class class-default
shape average 900000 If I take a look at the olicy-map on the in...
Hi!I have to setup an outbound shaping for a Telekom ethernetconnect line on a C9200L-48T-4X . It has the following parameters:burst size: 60.000 Bytesspeed: 1 Gbit/sAccording to this data sheet: https://geschaeftskunden.telekom.de/magenta-business-n...
Hi!
We ordered a WLC HA Bundle with 2x5508 controllers. Accidentally I swapped both WLC when I configured them.
After everything was installed, I noticed that there were no licences. Is there a way the get the licences from the backup WLC and move t...
@Joseph W. Doherty wrote:Ah, I understand your situation. Not that uncommon with carries that offer bandwidth limits less than physical interface bandwidth.Generally, for what you're trying to mitigate, Bc is not (too much) the variable we're inter...
Hi Joseph,sorry for missing the CLI part. Here it is:cpe(config-pmap-c)#shape ?
average configure token bucket: CIR (bps) [Bc (bits) [Be (bits)]], send out Bc only per interval
cpe(config-pmap-c)#shape average ?
<15000-100000000000> Target Bit...