Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!We are running 6.0(6) on all our IPS modules and appliances as suggested by our Cisco representative. We require to monitor them with Nagios tool but haven't been able to make the scripts we have to interpret the SNMP traps from the IPS.Is there a...
Hello,Regarding the configuration of the Cisco IOS content filtering, the certificate that needs to be downloaded from this page (http://cisco.com/en/US/products/ps5854/products_configuration_example09186a0080816c23.shtml requests the router's IP add...
I have not found any documentation on the version the module is using but I'm able to connect with SSH1 & SSH2.. is there a way of disabling SSH1 and allowing only SSH2??Thanks and regards,
Hello All, We have an ASA5510 running 8.0(4) with a CSC-SSM-10 module with the following characteristics:Hardware version: 1.0Firmware version: 1.0(11)2Software version: CSC SSM 6.2.1599.4Once in a while the CSC-SSM module appears as unresponsi...
Hello, We are noticing a strange behavior with several IPS AIM modules and IPS Appliances. Events are generated and can be seen from the event viewer but nothing is displayed on the Network Security Gadget on the Dashboard. We've verified and compare...
Thanks for the information. I can't select the correct answer since it was not my question. Let's hope the user who created it had his problem resolved.Regards,
Hello!Thanks!We are using Nagios to monitor the IPS modules and appliances we have, however so far we are only using ping to verify if it's alive. We would like to catch the SNMP traps that contain health information from the appliance, but we haven'...
Hello!As far as I know, the best practices are to select only "ip" for the access-list applied on the crypto map.If you want to limit ports you can do it on your inside access-group ACLs for both ends or use a VPN-FIlter on the ASA.Here's a sample co...
Hi! a few questions:Is there a device between the inside PC and the ASA5505? or Is the PC on the 1.1.1.x network and the default gateway of the PC is pointing to the ASA inside interface?If you run a "sh xlate" after trying the ping do you see the tr...
