About tonio.ojea

tonio.ojea · 09-19-2010

Hi, I want to pass all vlanes from a client. I have a tunnel-port in both 3560 and then I have an mpls xconnect between 6500. The 6500's are connected with a pvc with encapsulation aal5snap. This is the schema:3560 --Gb -- 6500 -- ATM PVC -- 6500 -- ...

tonio.ojea · 11-01-2010

You have to configure IP over PVC in both routersR1interface ATM1/0.1 multipoint description R1_2 ip address 1.1.1.1 255.255.255.252 pvc 1/66 protocol ip 1.1.1.2 encapsulation aal5snap !R2interface ATM1/0.1 multipoint description R2_1 ip address 1....

tonio.ojea · 10-20-2010

You have the configuration of the 6500 in a previus post.However, if I set up a pseudowire between two routers that are at my edge I can only carry customer VLANS with one tag. The problem is that customer VLANS double tagged are not carried by the p...

tonio.ojea · 10-18-2010

The frame size is always greater than 1540. I have read posts in this forums saying that only router based platforms can do xconnect with QinQ frames, but the 6500 need special cards so it can do it.I think that this is a bad issue on 6500s and we ha...

tonio.ojea · 09-20-2010

This is the current 6500 configuration, I have tried with the same result this configuration and other using subinterfaces. The xconnect works because I could see the untagged frame int both sites. The interface Gig1/9 from the 6500 is connected with...

tonio.ojea · 09-24-2009

You could use an access list in your wan interface denying incoming tcp connections with the syn bit active, like thisint FaX/Xdesc WANip access-group 135 inip nat outsideaccess-list 135 deny tcp any (publicIp) (public network) synaccess-list 135 per...

Member Since	‎09-24-2009 01:30 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	6

User Statistics

User Activity

6500 xconnect and QinQ frames

Re: Configuring LS1010

Re: 6500 xconnect and QinQ frames

Re: 6500 xconnect and QinQ frames

Re: 6500 xconnect and QinQ frames

Re: NAT static and connections outside-to-inside