Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, Please see the attached diagram.I have a customer whose AAA server is behind a firewall. It will only accept RADIUS packets from one source address - 192.168.46.1In order to facilitate this, I have added a router to statically NAT the RADIUS...
I have a customer who is reporting instability.I installed a SolarWinds NPM Eval to get an overview of the proceedings.In one hour, one interface reported 14 billion discards!!!!!OK - So sporadically (seemingly) this happens throughout the LAN.Byte c...
Hi All,I have a customer who has a WLC 4402 and 4 ancient 1000 series AP's.They need to extend their wireless estate. I plan to upgrade their controller to 7.0.98.0 and install 10 shiny new AP1142's.Does anyone know if the 1000 series AP's will still...
Hi all,I am unable to run ASDM and it's drving me potty.The ASA is running 802-K8.bin and has ASDM-602.bin.I have tried all of the obvious stuff - Latest version of Java, clearing the cache, different browser(same problem with Firefox or IE,) reinsta...
That their firewall config was bunkum.They have amended their config and it's all working fine Thank you for your input. Logic said that the problem was on their side but the ICMP issue threw me.Thanks again, Jason
Hi there, The firewall must be in routed mode.I agree that the MAC addresses look messed up:Internet 192.168.46.254 0 0000.5e00.0002 ARPA FastEthernet0/0Internet 192.168.46.252 84 0010.f333.c916 ARPA FastEthernet0/0Intern...
Hi mukeshjindal, The two key points that spring to mind is where is the root bridge?If the switch you are adding is an edge / access device, make sure it has the default bridge priority of 32768.As long as your root bridge has a lower priority (0 pre...
