Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody, I have a trouble with an IPSec tunnel between two routers. When I do a ping then use the command "show crypto ipsec sa" I have 0 packet encrypted and 0 packet desyncrypted too. Here is the configuration of the two routers:
Router 1:
...
Hi, I tried to upgrade a cisco switch 2960 while transfering the OS by XMODEM (baudrate: 115200) but when I did it I forget to set back the baudrate to 9600 before booting on the new flash. Have you got any ideas for setting it back? I tried to go ba...
Thanks for your answer but I think that the adddress are correctly fixed:
Router 0:crypto isakmp key 12345 address 192.168.60.1
Router 1:
crypto isakmp key 12345 address 192.168.60.2
About the ping, I did an access list which matches with any host...
Hi, here is the show:
Router#show crypto isakmp sa
IPv4 Crypto ISAKMP SA
dst src state conn-id slot status
IPv6 Crypto ISAKMP SA
I'm pinging one PC in my DMZ :
192.168.10.200
Hi, thanks for your answer. I had follow this procedure but when I set the baudrate back to 9600 it's work but when I go back to the normal mode this is like the rommon doesn't saved the setting so I have to go back to 115200
