Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a route being advertised by a neighbor router with IGRP that I want to block.Is there a way from my end to block that IGRP advertisement, or stop my router from seeing the route.The route that is being advertised is 66.0.0.0, on a private netw...
I am looking at building a network connection between two points that will utilize a DS-3.What Cisco Router would best suit my needs. Your assistance is appreciated.
I need to direct a print job from a remote site to a local network printer. The printer is addressed with an RFC1918 address 192.168.xxx.xxx. The remote network can not send traffic to an RFC1918 address because of internal policy.How can I proxy, ...
What are the pros and cons of using a full duplex setting between switches? Is there a reason you would not want to or a reason you would want to.I am currently using half duplex setting (Auto Negotiated) between Catalyst 5000 series switches over 10...
you may be able to apply the nat to a sub interface on the serial port. Route the traffic destined for the 199 network to the sub interface, and then it will get a address translation.All other traffic will go out the primary interface.
Set the IP route for the router address for other addresses outside of the native switch network. This network will always come up as default on the switch when configured.
