Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to start using NAT on our PE nodes but I cannot get it working. I have a lab setup with two vrf's terminating on the same node. In the lab I would like to NAT an address(Arguments sake a server) in the one VRF (Customer-C) to a unique ad...
Is there a limit to the number of static route one could use within a VRF ?We have a large customer connected to MPLS VRF based backbone and due to various limiting factors this customer uses static routing from a PE-CE perspective. We have been expe...
Can anybody supply me with links to good info as to the reason for running IS-IS as opposed to OSPF with MPLS ?We are going to design an ISP type network with MPLS and being a large network I would like to design it to be very scalable thus the quest...
Is it possible to run two ADSL or G.SHDSL. routers back-to-back ? A customer has two sites which he would like to connect with maximum data rate as he has a line between them , the line however is not clocked at either end and is only a single pair c...
We have an MPLS VPN based network based on leased lines. One of the VPN's connects to a banking service , a number of the other VPN's would also like to make use of this service. I would like to export the specific route from the "Banking VPN" into ...
I am also suspecting a bug although I have not yet done a bug search for something like this , the vrf is going on 202 routes but I also checked the link you supplied and from that this should not be problem. This scenario has occurred again and...
From your example it is difficult to see which network is running EIGRP as there are no network statement under the EIGRP process plus your AS numbers under the interfaces do not match you EIGRP "AS" number i.e. 1000 vs 2000.Apart from this I would ...
You can use reverse telnet where you connect a console cable from the aux port to the console port of the routers in a daisy-chain config , you then connect from the one to the other by issueing the telnet command with a specific port number. Here ...
A standard rate-limt works well for this type of thing if you are planning on capping traffic through a specific interface with either a transmit or drop action. The MPLS EXP bit enters into the equation if you are planning on QoS accross an MPLS ba...
I am not certain whether 12.0(3) will do CBWFQ or LLQ but it should do older forms of QoS i.e. Custom or Priority queueing. If possible upgrade to a 12.2 version of IOS as this supports all the QoS formats on either an IP or IP Plus flavour dependan...
