Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hardware:WLC 9800-CL on Hyper-V - 17.9.3 Cuppertinoc9210i API'm trying to setup an SSID with WPA3 Personal security only but I'm running into a weird issue with both Windows 10 and Windows 11 (My Pixel5 doesn't seem to care)If I configure the SSID wi...
I have a Nexus 3172T NX-OS v9.3(8) with two ports bundled in an LACP EtherChannel. The other end of this is a Windows 2019 server with Windows LACP NIC teaming setup. This has been working fine for quite some time then suddenly I'm finding this ser...
I've configured my Nexus 3172 for RADIUS authentication which is working, however, when I make the NPS (RADIUS) server unavailable either by stopping NPS service or disabling the RADIUS Client for this switch the fallback to local login isn't working...
I recently purchased some 1532 outdoor APs and could not for the life of me figure out how to get them registered with the WLC until I read a post that said I needed to add the AP's MAC address under Security, AAA, AP Policies. Sure enough, this res...
I'm new to the Nexus switches and could use a little advice on link aggregation and QSFP+ to (4) SFP+ (QSFP-4SFP10G-CU5M cable).I have a new Nexus 3172TQ that will be installed as a top of rack switch and will uplink to my core Catalyst 4500x via bre...
This an old thread but I ran into this issue today trying to re-deploy Prime installing 3.10.2 System Patch. I had renamed the files adding a numbered prefix as I downloaded a half dozen updates and I wanted to tag them for installation in a certain...
This is happening in Windows 11 22H2 as well. When I show the wlans from netsh it's showing my network as static WEP open which makes no sense because I have it configured for WPA3 CCMP SAE+FT (also tried disabling fast transition). Any idea what's...
Thanks but the drivers are already at the latest version and this is happening on 3 separate Windows machines with both Broadcom and Intel NICs.My goal isn't to configure SAE transition with WPA2 + WPA3, I want SAE with WPA3 only.
@MHM Cisco World wrote:When port go to errdisable before you shut/no shut try my way the port automatic recovery and you can see what was the reason make port go to errdisable status.You are welcome I will try this next time the port-channel goes dow...
