Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to run the following commands on a 2801 router, but the commands are missing:mls qos mls qos map cos-dscp 0 8 16 40 32 46 48 56The only QoS command i have in global config is (no MLS qos) :REMOTE-ROUTER1(config)#qos ? restore-show-output...
I have a particular site that is causing me trouble, this site is connected in a back to back configuration using 2811 at CO and 2621XM at CPE. The CO end is also the CO for 3 other sites so has a total of 4 wics installed (WIC-1SHDSL-v2), these oth...
I am trying to allow magic packets from our management servers to client PCs located over routed links. The management servers are on addresses 172.22.200.54/16 and 172.22.200.63/16They are directly connected to a 6500 to vlan 1 (GI 1/30 and GI 2/14...
We use Nortel IP phones (1140E), according to the Nortel documentation Voice media is tagged by the phones as DSCP 46 and Signalling as DSCP 40.Can someone tell me where i have gone wrong! On my switch (3750) i trust the DSCP and have the cos-dscp ma...
I was looking at ERSPAN to monitor VoIP traffic from a remote site (from VLAN300), the remote site has a 3750 (WS-C3750-PS-S) with one interface in routed mode that connects to the 6500 - again a routed port. The server that will be analysing the rem...
Ryan, what i am (maybe mistakenly) trying to do is copy the same config off the current router on to the new router.all clients connect a 3750, which mas the cos-dscp map, which in turn is trunked to the router:3750mls qosmls qos map cos-dscp 0 8 16 ...
Paolo, if the helper address goes on the interface that recives the broadcast, in this instance is that vlan1 that would need a helper address specified?Are you also saying i need to configure an ACL to be able to specify the port used for it to work...
Soroush, i have about 6 client PC's that i need to be able to wake up so i was going to go to use broadcast since it will be the same management servers sending the magic packet, i thought it easier to do it this way.ThanksJeff
