Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After rebooting a pair of 6504's configured for vss, both switches show active on the sup modules. A show switch virtual redundancy however shows the pair working in an active/standby mode. We have 6509's in vss pairs and they show active on switch1 ...
Hello I have been trying to upgrade the Nexus OS on a Nexus 5010 in a staging area. After configuring the mgmt0 interface and my laptop on the same subnet, I can ping the switch from my laptop but canot reach my laptop from the switch. I get an error...
Are there any compatibility issues with ver 3.2 CSM code with the SUP720? My two CSM's in different chassis were working and after upgrading from SUP2's to SUP720's I cannot get FT to work. Both CSM's come up as active active and I have to shut one d...
I have two CSM modules in two differnt switches (Bridge mode) configured for high availability. After noticing one of the CSM modules was in failed mode, I reset the module. While the module reboots I get the following messages: %CSM_SLB-4-REDUNDANCY...
I have two WISM modules that support just over 350 AP's. Can the WISMs be configured to provide failover for AP's at another site connected over the WAN.Thanks, Donald James
#sh switch virt roleSwitch Switch Status Preempt Priority Role Session ID Number Oper(Conf) Oper(Conf) Local Remote------------------------------------------------------------------LOCAL 1 UP FALSE(N ) ...
The plan is to take a working CSM from a DR site with the same config to try in place of the not working active. I did not want to risk taking the working stanby and moving it and possibly having an outage at this time since this is a production swit...
