Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello community,I've got to configure ISE posture with AnyConnect & ASA for remote access VPN and I get the following error message right when system scan tries to contact ISE server for posture checks. VPN tunnel ok,DNS resolution ok,compliance modu...
Hello all,
I'm trying to find an IOS image that is not listed on the "download software" section of a device, particularly for ASR1001X and version 152.4(S4). Is there any way I can find this version? Is there any archive for old or discontinuous IOS...
Hi Jeremy,How can we have multiple YANG Suite preferences files (/home/user/.config/yangsuite/yangsuite.ini) in a Python installation?Is there any option to save different files per each venv we create? Thanks
You won't see any VNI on any switchport (either physical or virtual) other than the NVE interface. Only the VTEP interface can encapsulate/decapsulate VxLAN packets on a VxLAN/EVPN enabled device.Keep always in your mind that all VxLAN/EVPN traffic i...
It wasn't AnyConnect's fault. The error message came up from ISE server and soon I rebooted the ISE server everything came up normal, no error after that.
The same VLAN-ID (VLAN1-to-VNI1) can be mapped to a different VNI (VLAN1-to-VNI2) on another VTEP in the fabric, and then the new VLAN-to-VNI combination can carry a whole different kind of traffic and it can also be assigned a different IP address s...
