Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have UC520 and use SIP trunk to ITSP for PSTN connection.Both inbound and outbound call works fine.Have issue with hairpin issue, when the PSTN user call the inbound DID via SIP trunking, IP phone extension could take the call and transfer to other...
After setup EZVPN for UC500, the vpn client could get IP address from pool. following is the setupUC520 internal Interface 10.1.1.1/24define Ip address pool for VPN client as 10.1.1.200 to 10.1.1.210client connect to UC520 successfully, and acquire I...
I have UC520 the conference between three IP phones was working, but now stop working, this might caused by adding extra feature configuration into phone, but not sure what cause this conference stop working.Double check the DSP registration, all see...
Have UC520 box, voicemail is working, but MWI light not light up after left the message. Following is the configuration for CUE.ephone-dn 5number 8001... no-reg primarymwi off!!ephone-dn 6number 8000... no-reg primarymwi onand with two Test phones, w...
This is my setup:1. Cisco Automuous AP - 1131AG-A-K9figure with 3 VLANs and 3 SSIDs, one SSID for each VLAN.2. Running code version: c1130-k9w7-mx.124-10b.JDA33. first SSID - faculty-1,VLAN201 , confiure with Cipers TKIP and WPA, and passphrase.4. Se...
The orginal IOS code was uc500-advipservicesk9-mz.124-11.XW7, The New System image file is "flash:uc500-advipservicesk9-mz.150-1.XA"This has resolved both outbound PSTN Call transfer and trasnfer to voice mail issues.
Hi Steve,It does not appear to be Codec issue, attached please find the log and run config. Thanks for advice.following is call flow:One Inbound DID 718-679-9908, when call reach the UC520, it translate into extension 100, which is a shared line on L...
