Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I need to know if the STP-SFP+-LR Wavelenght 1310 10km from other venders will be compatible with the Cisco Nexus 3065 switch. I know you can run switch(config)# service unsupported-transceiver switch(config)# no errdisable detect cause gbic-inva...
Hi GuysI have a pbx on my internal network on ip 192.168.1.4 and need to open udp port 5060 on the PIX 501 to point to the IP:Here is my access-list and static route is it correct, because my SIP account doesn't want to registerd?fixup protocol sip 5...
Hi,I need to add a subinterface to the interface1 (inside) interface to my PIX. What I want to do is to add vlan100 to the interface. With a IP address.Everytime I try to go interface ethernet1.100 it will just go back to the router(config): and not ...
Hi,Can I create a PPTP VPN and a client connection on a PIX 501 with a PPPOE client connection to my ISP. The PPPOE ip is dynamic and the VPN will have a static IP. They gave me a username and password for the VPN and PPPOE. The also gave me a ip for...
HiI am pritty new to the pix config. What I am struggeling with is to get inbound access to my mail server on port 25 from my outside interface ( PPPOE)I also can not get SSH access to the outside interface to my PIX.I have been trying everything I k...
Thank you.I am going to cancel with the ISP and move to someone els. They have sold the wrong solution, will not catch me out again.Thank you for the help.Etienne
Hi,Cool, this answerd my question. Now I know that a PIX can only be a PPTP server.See for me to use the static IP, that I will get from the PPTP connection to the ISP I have to create it on my Server. I will allow port 1723 to passthrought the PIX t...
Cool, this helps alot.If this is out of the scope of this discussion I will open a new one.I do have a public IP but I can only use it when I create a client PPTP VPN to my ISP. I tried to created one on Router 837 but read that you can not create a ...
Hi MikeThank you for the replay,I have a PPPOE dsl connection on my outside interface so my IP is dynamic. If I try to put something like:access-list incoming permit tcp any host interface eq 25 I get a reply interface in not a parrameter. I understa...
