Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings,For security purposes I have my wireless access point sitting in a separate VLAN on my switch, trunked to the virtual DMZ interface on my 506e. That part works great, and the wireless clients can get Internet access out through the outside...
Greetings,I have an IPSEC VPN set up on a PIX 506e for inbound traffic into the inside of the network. I also have a DMZ set up for wireless, trunked from a 2950. The wireless DMZ works great, and outside access works from both the inside and the D...
Greetings--I am working on putting together a Cisco lab, and to that end I have a PIX 506e on the perimeter of my home-network (replacing an ISA box). The PIX is configured with the standard out-of-the-box setup, with a couple of changes (no DHCP Se...
You've probably already figured this out, as this post is a bit old now, but the N1K doesn't support FabricPath. Unless I'm missing something, you can't do what you want to do using only the N1K. Other things might work, VXLAN of course.
You are right about the two interfaces on the 506e, and I was wondering if that might be an issue. I was hoping that the virtual/logical interface would count in all ways as a de-facto separate interface.So it sounds suspiciously like I may need to ...
I appreciate the reply, but after more fiddling I still haven't been able to make this work. The inbound VPN works fine (from anywhere), but I can't get VPN from within the DMZ to the INSIDE to work. I've included my edited config file in hopes tha...
