Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Team,we have a problem in routing between primary and secondary links.we have a two office and we are connected with intranet 2 Mb and we have configured back-up Site-Site VPN on firewall for remote office.Now the problem is when the primary is...
Hi All,I have 2 4006 switches in my network. I have configured DHCP on that switch. Now my problem is few of the printers which are in this DHCP vlan are getting DHCP address. even if the printer is set in ip address, it is again getting DHCP addres...
Dear Team,I have a problem with LWAP. i have 2 wireless stand's 802.11a and 802.11b/g configured in WLC. one of the lwap which is registered with controller appers in yellow in 802.11g, if i click all lwaps monitering mode but it looks green in 802....
Dear Team,We are facing routing problem in my network,We have 2 ISP's in my network ISP 1 and ISP 2. My requirment is to route one of the VLAN traffic to ISP 2 and all other traffic to ISP 1. Please find the attached doc for refer. Please suggest me ...
Hi Team,I am having 10 Lwap with 4404 controller in my site.I am facing problem with rauge ap's.I am not able to connect to my network.There are 100 rauge ap near my site....i think my controller is not able to provide channel to my ap's.Please sugge...
Why Can't we configure this for automatic routing between our leased line and VPN links? A End in 4506ip route 10.54.0.0 255.255.0.0 10.0.0.101 1ip route 10.54.0.0 255.255.0.0 firewall 2 B End in 3560ip route 10.126.0.0 255.255.0.0 10.0.0.102 1ip ro...
Hi,In between my 4506 and router there is cisco asa 5520. Please find the network dig.Is there any other way except PBR, since my switches are all IP base.Regards,Satya.M
