Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am using a MX68 and a WS-C2960X. I want to connect 5 LAN ports on MX to 5 sw ports on c2960x with trunk mode and bonding it to achieve a 5Gbps bonded connection.How can I do it? Thanks
I have an AP 2802i. I have just converted it from CAPWAP to ME (ver: 8.10.196.0).This AP is configured to AP & Controller mode.I created 2 SSID - 1 for 5ghz only (wlan1) and 1 for both bands (wlan2)The wlan 1 cannot be enabled and The wlan 2 cannot b...
I have 2 sw-c2960X. I was readed manual Catalyst 2960-X Switch Stack Manager Configuration Guide, CiscoIOS Release 15.0(2)EX.
I see part mode Homogeneous stack, but i don't see they say about bandwidth in this mode. Pls help me
No, I mean a solution which can utilize a redundancy protocol like VRRP. There are 2 trunks connections between MX and WS. One can standby for failover functionality.
Thanks connorL, so is there any solution to configure a pair of physical ports on both devices as "trunk" ports, enabling VLANs to be carried across the connection?
Thanks @Rich R after done I have realized that Marce was aiming to get log of show run-config in ME WLC CLI. I had done it in apciscoshell so that why I provided a wrong log.For channel to apply 5Ghz band. Do you think radio band U-NII 1 & 3 good to ...
