Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone come across the above. Configuration on the router and KiwiSyslog server are all OK. I have removed the logging on the router, reloaded and re-configured but still no joy. Any suggestionsThanks in advanceKoen
HiCan anyone tell us what the order is to remove traffic shaping on a hub and spoke topology. We tried removing the TS command on the physical interface on the hub with a result that all the spokes went down. When we tried to remove the map class fro...
HiI was wondering if it was possible to change the server they hosts authenticate on via DLSw or does this has to be done on the actual hosts themselves?Thanks in advanceKoen
Hi We are having problems when using 100Mb/Full on the AP and switch. There are 3 other APs on the switch using that config. The switch doesn't have the speed/duplex setting on the ports and the AP is on auto. The only way to get the AP working i...
Thanks for the advise, got some more information in the meantimethere is a vofr cisco on that DLCI as well and a hold queue on the physical interface (hub)
Hi SteveYes we did, we did the switch first and let the AP autosense, no joy. Then the other way around AP 100/Full and switch autosense but still no joy.It works only on 10/half and a hub while there are 3 others on there that work fine, weirdKoen
