Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have to mirror one source port to multiple destination ports. In detail, the destinations are 3: eachone should mirror the traffic from source in everyone of three different mode: both, tx and rx.Hoh many are the needed session? I guess 3, is it ri...
I have a WLSE 2.0.2,When I try to import a template from an AP1200 IOS 12.2(11)JA1, it fails with a "Login failed. Wrong credentials" error.Monitoring the TCP connections at the access point, I see that the WLSE tries only a telnet connection that fa...
Unfortunately the Aironet's Cisco IOS supports BVI interface only on native VLANs. You have to configure "encapsulation dot1Q 201 native" on the FastEthernet0.201 subinterface and then you should modify coherently the configuration on the switching i...
The hub could be fine for the "both" mirroring. What I want to do too is to split the TX and RX traffic of the same port sending each flow to two different destination ports. I didn't find any similar example in the documentation.Can I set two differ...
Yes, I had. Actually it is under Administration->Discover->Device Credentials->Telnet/SSH User/Password.If Telnet were allowed the login sequence would be:Username:Password:prompt >enablePassword:enable prompt #SSH would be the same except that the "...
With the "ip opportunistic disable" you'll disable only "opportunistic" layer 3 routing, as defined in the "Basic Configuration Guide". If you refer the CSS VLAN ip address as the default router of an attached node, then the CSS will route traffic be...
