Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would greatly appreciate for any suggestion with regards recording solutions for CCME. So far we have tested ANDPhone solution but our customer insist to have a windows based solution.Please advice,Vladimir
We use to work fine with ATA-GK-AS5300 IOS12.2(10a) but after upgarade IOS to 12.2(11T) setup of the call going well but voice always available only in one direction from AS5300 to ATA186. I'm sure that is not a codec issue because I did try four dif...
Dear All,previously (Conversation title: How to set CLIR on ISDN?)I have asked about enabling CLIR on PRI for AS5300. As I found out the CLIR is an option in 'setup message' on ISDN signalling level. In our county we are currently using DSS1 protocol...
I can't find how to set Calling Line Identification Restriction (CLIR) on PRI line. Is any body have idea how to set it up on AS5300?Thanking in advance,Vladimir
Hello All, We upgraded some of our access servers to 12.2(3) series and noticed the lack of AAA SESSION MIB. This MIB is important for us to track double logins on our RADIUS server - I couldn't find any other way to track both analog & ISDN logins...
Dear Don,I couldn't make RPR+ working on Cisco 7507 with IOS 12.2(14)S3. I did try it on two different routers one with two RSP4+ and other with two RSP8. In both cases after manual syncronisation I manage few times to keep router in rpr+ mode for a...
