Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
There appears to be an issue with the output of the Macro Report v3.6 where the 'Custom Inventory' tab appears to have the headers and data mis-aligned.
As an example, Column E, has headings of 'Equipment Type' & 'SNMP Location' but the data ro...
I am trying to generate the consolidated report using the Cisco supplied Smart Service Upload and Reporting macro. I can load the macro spreadsheet ok (Macros are enabled in Excel). The Inventory report import works OK, however, when doing the Produc...
I have previously had a number of IP addresses included in the "Do Not Manage Devices List...", however, I have now deleted these IP addresses from the list, however, when starting a device discovery (using the IP's as removed from the list), I get a...
Hi,
I've uploaded an inventory from our collector this morning but even after several hours nothing is showing in the 'Upload Processing' page on the portal?
The appliance indicates it has successfully uploaded the report but nothing on SNTC Portal?
...
I've been doing some reading around and it appears to be reasonably simple to monitor the connection rate and total connections through an ASA. However, I'm looking to be able to monitor the number of connections and their states at a given time - i....
Appreciate that running the repair allows you to use the file, however, I'd suggest that this was only a temporary workaround?Is it possible to get this looked into? Something must have changed in a recent release to break the report output?
Hi Luis,
Thanks for the response. Unfortunately that OID gives the current & max count of connections but does not actually return the state of those connections -
[XXXXXXX@xxx-xxxx-xxxxx-001 ~]$ snmpwalk -v 2c -r 1 -t 1 -c xxxxxxxxx xxx.xx.xx.xxx 1....
