Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Something wierd happening . . . A few months ago, the power supply failed on two switches on two different stacks (one on each stack). I got replacement switches from TAC and installed them. Now, I'm finding that CNA cannot see those two switches. It...
I have not been able to mirror firewall traffic to surf control since we changed switches to catalyst 4506. I have the following commands entered where Gi5/23 is the firewall interface and Gi5/12 is the SurfControl interface:monitor session 1 source ...
Just got Kiwi Syslogd and now I'm seeing things I was blissfully ignorant of before .... I have a printer that's connected to a port that's set to auto duplex and auto speed. The printer itself does not have a way to set the duplex/speed. It is nego...
I have a Catalyst 3550 that won't keep it's clock setting. Notice below, that when I set it, there is a dot pre-pended to the time. None of the other switches have this.cat3550p#clock set 18:42:00 Mar 12 2005 cat3550p#sho clock.18:42:05.379 EST Sat M...
Thanks, Andras.I tried the sho switch and in both stacks, the newly added switch is Provisioned and MAC address is all 0's.SW-3750-4&7FL-PTR#sho switch CurrentSwitch# Role Mac Address Priority ...
What finally did it for us was adding encapsulation parameter to the destination. I'm still a little unclear about which VLAN I should be using -- do you create one specifically for that port or use one that's already in use. We've got 6 VLANs in use...
Further on this .... The network card on the surf control server is receiving packets. It just isn't doing anything with them -- no send packets and nothing appearing in surf control. Thanks,Mary
It looks like the NIC card on that printer is actually hard coded to operate at half duplex. I changed the port setting to half and the errors went away. I guess that printer is an old one. I had assumed it would autonegotiate since you can't change ...
Since we don't have more than one of those Netgear miniswitches on any switch, I guess it's OK then. If they are really switches, then it doesn't apply in this case.Thanks for the info.Mary
