Dear all,help me for route or switching issueI have 7609 Router( Loopback- 10.99.0.174) which is connected to 2 Me3400 ( l2 Switch) like below10.96.16.36=========>10.96.18.100=========>10.96.16.517609.Interface.ip MES01--Vlan.Ip MES02--V...
dear all,i couldnot get the tacacs accounting logs for some of my network device groups,what can be the problem, device aaa configuration & server side setting are same for all Groups
dear all, When i am accessing one of my aaa client , which is getting authenticated from ACS Server 4.2 it is showinng as Authorization failure , what could be the issueconfiguration on device &server side is proper
Here is my L3 switch configuration,interface FastEthernet0/24 no switchport ip address 10.99.17.198 255.255.255.252 ip access-group cdrwest ininterface Vlan1 ip address 10.97.112.5 255.255.240.0!ip classlessip route 10.99.0.0 255.255.0.0 10.99.17.197...
Im having one of the customers Router(DAX) which is having theInterface configuration as belowinterface gigaethernet0 ip address 10.97.45.1 255.255.255.0 ip rip send version 2 ip rip receive version 2 exitinterface gigaethernet1 ip address 10.99.8.1...
I have added the route & Permitted the Redistribution of Static subnets in Ospf & Bgp Debug Output of Switch is as below 3550_SWITCH#ping 10.99.1.14 Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.99.1.14, timeout is 2 seconds:.......
below is the output which you have asked/ also the debug output& the subnetnetworks advertised are the same below for all ospfRoutersROUTER#sh ip ospf int s2/1/0:0Serial2/1/0:0 is up, line protocol is up Internet Address 10.99.56.25/30, Area 0 Proc...
ROUTER#sh ip ospf neighNeighbor ID Pri State Dead Time Address Interface10.99.0.180 0 FULL/ - 00:00:38 10.99.56.14 Serial2/1/6:010.99.0.179 0 FULL/ - 00:00:39 10.99.56.10 Serial2...