Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Setup for outside VLAN:1. Pix outside interface IP address 192.168.1.12. Internet router e0/0 - 192.168.1.33. default route on Pix - 0.0.0.0. 0.0.0.0 192.168.1.34. default route on Internet router - 0.0.0.0. 0.0.0.0 <next hop to ISP>I do not have...
Access-group statements always apply an ACL to an interface with the command "in interface <interface name>. The Pix docs say that "this filters inbound packets at the given interface". I would like a clear definition of what is inbound. My under...
I know that the static statement is used to access a higher security level interface from a lower security interface. Also, if you want to disable NAT you use the formula static (high,low) high high. I have used the same formula with the static com...
Since there are not any differences in RAM or interface limits betwen an unrestricted and a failover license, how do you know if you have a failover license running on a Pix?Thanks,RJ
I am running CW2000 with the followingCD one, 4th editionRME V3.3 with IDU v1.0VPN monitor v1.1I have a Pix 515 running v6.1(1). I am sure the SNMP read community is correct. When I check the device attributes, the telnet, enable and SNMP community...
If you are trying to manage/access the PIX from the outside, you can useSSH.First you need to have a DES or 3DES license on the PIX. The DES is a freelicense, you will just need to apply for it from this URL - http://www.cisco.com/cgi-bin/Software/F...
OK, I understand your points and they make sense. I guess I am not sure my initial question has been clearly answered. - How can I tell if I have a FO license? 3 possibilities?1. Sh ver - what identifies it?2. Serial number? Any part of it identi...
This is the same output as my unrestricted firewall. The failover license is enabled. 1. What is the difference in the failover vs unrestricted "sh ver"?2. Also, will a standalone Pix with a failover license pass traffic? Is there something in ...