Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
It's it normal to have layer 3 ACLs on an access switch? The ACLs are being used for QOS policys (ie voice, video) that are then applied to the interfaces. My question is, isn't everything at this switch going to be layer 2?
For reference here i...
Below is the sho int of the LAN and WAN interface of our 2811 (WAN) router. I'm seeing input errors and ignored increment at the same time on the LAN interface. I have hard coded speed and duplex on this interface and the core switch interface. You...
I know what Full Duplex theoretically means, but in real world terms say you have a 10 Mb circuit on a 2811 router, and RX is close to 100% utilization and TX 50%. If someone accesses a file server behind that router A --> B, would the RX at 100% ef...
Scenario is a 2 member 3850 (IOS XE) stack. Switch 1 died, Switch 2 is active waiting on 1 to be placed back in the stack. I'm being asked to fully configure switch 1 before adding back to the stack? As I understand it, Switch 2 has a full copy of...
I have a 3850 stack with 2 members. The master died and switch 2 took over. As you can see below, it's waiting on switch 1. I have it ready to configure, but I need some advice on how to proceed. I'd like the current configuration to remain, will...
Ok, so I'm seeing that the 4510R is one of these switches that can work in L2/L3 but I guess I just don't understand the use case. Everything coming and going from these ports should be Layer 2 I thought? I guess I need to do some reading on how th...
I don't see the auto-update enabled command in the running config... So does that mean it's just going to sit with a default config if I don't pre-configure? It should still "inherit" the config that's on Switch 2 correct?
That was my thoughts too, and even if it has a config on it, won't it still go through the process of overwriting that with what's on the Active switch? I think there may some misunderstanding from the person I'm working with about how this works. ...
