Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I've configured my AS5350 as shown athttp://www.cisco.com/en/US/customer/products/hw/univgate/ps505/products_configuration_example09186a0080094a49.shtmlwith the exception I'm using external authentication (CiscoSecure ACS) to validate users.Now, u...
Hi,I'm running a PIX 6.1(4) and the customer can happily dial into the Internet via a modem an connect using the 3.6 client but when he tries from behind his NAt'd router the tunnel comes up but no ip traffic passes.Reading the manual for the VPN cli...
I'm load balancing between 3 servers each running a web server via a single virtual address.The problem I'm experiencing is one of the servers, whilst it still listens on port 80, stops serving content. When this happens, the LocalDirector doesn't a...
Hi,I've configured a PIX520 running 6.0(1) and a Cisco 2600 router as per the online example, but without NAThttp://www.cisco.com/warp/public/110/39.htmlbut when I try to pass traffic over the tunnel, it gives the error message%CRYPTO-6-IKMP_MODE_FAI...
Hi Mak,A 'connected' route gets added upon authentication, all the debugs match what I'm expecting to see, cpu usage is non-existant, it all *looks* like it should work I know the aaa side is all good as I'm using RSA SecurID and it's telling me the...
I am having a very similar problem, only that it works fine for when I use DES, but as soon as I change to 3DES it fails at the phase 2 negotiation, claiming it keeps seeing duplicate packets. I have set up a seperate policy and all I'm changing is ...
