barry.ard
Level 1
Level 1
Member since ‎12-09-2005
‎10-21-2017

User Statistics

  • 11 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
First Discussion
5 Discussion Posts
10 Discussion Posts
1 Reply
5 Replies

User Activity

Currently I am graphing client counts by wlan using CISCO-LWAPP-DOT11-CLIENT-MIB::cldcClientWlanProfileNameThis has to be done for each controller and walking this can take upwards of a minute for our 9 controllers. Does anyone know of a table that h...
Some background:For a management application I need to retrieve the mac-address that a switch uses when tagging the remote-id field of dhcp requests when dhcp snooping is enabled. Specifically, when dhcp nooping is enabled, the remote-id field in a d...
Hi,I am working with a Catalyst 4506, IOS 12.2(25)SG, and it seems that the BRIDGE-MIB isn't working. Any pointers on how I might be able to get the CAM info from this switch using SNMP.Thanks,Barry.
Hello,I am looking for a mib that will allow me to read/set the duplex setting of an interface.To read the current operating status I can use ETHERLIKE-MIB::dot3StatsDuplexStatuswhich is a ReadOnly status.There are duplex references in MAU-MIB (DOT3-...
I need some assistance in locating the mib/variables to allow me to set a trunk port and add/remove vlans on that interface. The equivalent of:switchport mode trunkswitchport trunk encapsulation dot1qswitchport trunk allowed vlan 400,401This is on a ...
Community Statistics
Member Since ‎12-09-2005 08:17 AM
Date Last Visited ‎10-21-2017 11:25 PM
Posts 11