Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We run a simple eigrp network with one default gateway (redistribute static routes on) and one firewall.In the coming months we are adding a second DC and will be using HSRP to span some networks, Along with some 3rd party network equipment.My questi...
I'm planning to span my datacenters. They are directly connected with dual 10 gig fiber links using LACP. I'm using 4510 with sup 7sI'm using OTV methodology without using OTV. I want to isolate my HSRP sites so they each have the active gateway. In ...
I'm looking for a simple solution to handle my out going internet traffic. The solution can be load balanced or failover. I have two datacenters, both have an internet connection. Internally I use EIGRP for routing between all my 4510 Switches.The f...
I have a multi site cluster that I'm looking to improve the redundancy on.Each site has a 4510 Chassis that are interconnected with two indepented fiber runs (etherchannel), utilizing 10gig SFPsCurrently each switch has vlan 10 trunked across to each...
I have two sites connected by 96 strands of fibre. At each site I have an IBMv7000 relicating to the other one. For iSCSI traffic I have two Cisco 3750 switches, each are in 2 switch stack. SAN A Fibre Link ...
Excuse my ignorance, I'm a sys admin first network admin second. In your scenario am I setting up the unequal load balancing on the 4500? Is that just advertising a static route through eigrp? Right now with only one ISP I just advertise that default...
awsome. Just to make sure I'm 100%. Clients in "Site C" will see both eigrp advertisements, one for 10.10.0.0 via 172.16.201.1 and one for 10.10.0.0 via 172.16.200.1?I'm not too worried about the HSRP, I've done that before. I just want to make my ei...
