Well we still have some of those apparently. I tried the upgrade an AP via the archive commands without the tool, and the AP did not recover so I am going to have to take it down from the ceiling and probably need to pull that cert off of it. I sh...
Thanks Scott, I just didnt think the WLC had that as a configurable variable, but I can see that once the AP is connected to a controller those commands start to become available within the CLI on the AP. It just cannot be adjusted if the lightweigh...
What if the AP is in lightweight mode? It does not let you into global configuration mode, and I cannot find any settings for changing the boot in this mode. I am hoping this doesn't require reverting the AP back to autonomous just to make that ad...
I have recently came across this issue and I can bet that the main cause of this is the 2960S casing. It leaves the USB slot slightly deeper than most other Cisco device casings that have USB, which means that the USB flash drive does not get fully ...
