Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all Following design: i have a AP 2802 connected to a cisco Switch. Also connected to the switch is a WLC 5520. I wonna that the AP discovers the WLC that i can manage the AP over the WLC. Following Configuration on the Clients: SW: interface Gi...
Hi all I have a question about the WLC N+1 redundancy. I have 3 Cisco WLC 5520. Can i configure one as Active, one as Standby and the last one will take over when the active and the passiv are down. The failover should be like this.1. Active fails2....
On the Switch the ports are in vlan 1 and on the wlc in the vlan 0. So this should be okey. right? What i recognized is that... The switch is connectet over SFP to the WLC SFP port 1. The statuslights of the WLC are like this:The 10GbE light does not...
Hi Scott Sorry I was a littlebit confused. I have a SSO Cluster and have to configure one as secondary. You still prefer a skript to apply this settings on all AP? CheersOliver
So i have to configure on every AP the high availability? As primary i configure the active wlc, as secondary the standby and where does i have to configure the the thrid (backup)? is this the tertiary?Or does i have to configure like this:The active...
